求大神帮忙翻译一下 材料方面专业的英语翻译 剩两天了 求帮忙啊 不要机器翻译的

求大神帮忙翻译一下 材料方面专业的英语翻译 剩两天了 求帮忙啊 不要机器翻译的
The S/N response data and diagram are given in Table 5 and Fig. 2, which were used to determine the optimal control factor settings to maximize the shear layer thickness. Table 5 presents the S/N response values at three levels and the effect of each factor on the S/N ratio. Figure 2 illustrates the effects of control factors by showing S/N values at three settings of levels for each factor. The factor settings corresponding to the greatest S/N ratio should be the optimum process conditions. Using the best levels of control factors should yield the maximum effective thickness of the shear layer. In Table 5, a higher value of the effect represents a greater influence of the control factor on the effective thickness. Hence, the table shows that the most influential factor is the filling time, followed by the mold temperature and the injection speed. In order to decide which level is better to obtain the maximum thickness of the shear layer, the S/N response values were compared at three setting levels for each factor. According to the S/N response table and diagram, the best combination for the process condition should be A3B3C1D2. The best levels of processing parameters that can maximize the shear layer are 7 s for the filling time, 310°C for the melt temperature, 65°C for the mold temperature, and 60% for the injection speed.